nato metal gas can is a robust
fuel container made from pressed steel. It was originally designed
in Germany in the 1930s for military use and holds 20 litres
of fuel. The development of the nato metal gas cans were a huge improvement
on earlier designs, which required tools and funnels to use.
In 1939, an American engineer
named Paul Pleiss had built a vehicle to journey to India with his
German colleague. After building the car, they realized they didn't
Pleiss told American military
officials about the nato metal gas cans, but they ignored him. Without a
sample, he realized he couldn't get anywhere. He eventually got the
car shipped to New York by a roundabout method, and sent a military
metal gas can
to Washington. The War Department decided instead to use the WWI
ten-gallon nato metal gas can with two screw closures, which required both a
wrench and funnel for pouring.
At the beginning of the Second World War, the British Army were equipped with simple rectangular fuel containers: a 2 gallon (9 litres) container made of pressed steel and a 4 gallon (18 litres) container made from tin plate. While the 9 litre - 2 gallon containers were relatively strong, they were expensive to produce. The 18 litre - 4 gallon containers, which were mainly manufactured in the third world, were cheap and plentiful but they were not very robust. Consequently they were colloquially known as flimsies.
While adequate for
transportation by road in Europe, the flimsies proved to be
extremely unsatisfactory during the Northof
the fuel being lost as the containers were easily punctured. The
resultant leakages also made the transportation vehicles liable to
The sides of the nato metal gas can were marked with cross-like indentations that strengthened the military steel gas can while allowing the contents to expand, as did an air pocket under the handles when the nato metal gas can was filled correctly. Rather than a screw cap, the containers used a cam lever release mechanism with a short spout secured with a snap closure and an air-pipe to the air pocket which enabled smooth pouring (which was omitted in some copies). The interior of the military steel gas can was also lined with an impervious plastic, first developed for steel beer barrels that would allow the cans to be used for either water or gasoline. The nato metal gas can was welded, and had a gasket for a leak-proof mouth. The British used cans captured from the "Jerries" (Germans) — hence "military metal gas cans" — in preference to their own containers as much as possible. Later in 1940 Pleiss was in London, and British officers asked him about the design and manufacture of the nato metal gas can. Pleiss ordered the second of his three nato metal gas cans flown to London.